Asus E500-PIB Guía de usuario descargar pdf (Pagina 45)

41 • Schlage • Schlage Utility Soware User's Guide

Controller PropertiesAD-Series Locks and Controllers

PIB300

VIEW Tab

Property Description

General Properties

Model Model of the device connected to the HHD.

PIB

Firmware Version Version of the ﬁrmware ﬁle. Automatically updated when a new ﬁrmware ﬁle is loaded.

Bootloader Version Version of the current bootloader. Allows new ﬁrmware to be loaded.

Serial No. Serial number that uniquely identiﬁes the device.

Manufacture Date Date the device was manufactured.

Days since Installed Used for warranty purposes; marks the beginning of the lock’s functional life.

Hardware Version Current version of the printed circuit main board.

EDIT Tab

Property Description Default

Standard/ Legacy VIP RS-485 network communication format: Standard (Schlage RSI RS-485 protocol)

or Legacy VIP Protocol.

Standard

Number of doors Number of doors connected to the RS-485 network. 2

Lock 1 Address RS-485 address for Lock 1, Range: 0 to 255 0

Lock 2 Address RS-485 address for Lock 2, Range: 0 to 255 1

Output Type Magnetic, Wiegand or Automatic. Outputs the Credential Card and Keypad data in

either Magnetic or Wiegand format.

When Automatic is selected, the PIB300 will detect the Credential Card and Keypad

data format and then send the received data in its original data format.

Automatic

Host Control: LED

Control

Off= two-line led control of lock led indication

On=single-line led control of lock led indication

Host Control: LED

Standard

Off=led standard (active low signal from access control panel)

On=led invert (active high signal from access control panel.)

Host Control: LED Style Off=led style std. (For use on two led system.)

On=special case. If panel tries to light both leds (at the same time) neither of them

lights.

Beeper is not controlled by panel with this switch on. S1-1 must be set to off when

this switch is set to on.

Host Control: Lock

Control from ACP

Off=normally open lock control from panel

On=normally closed lock control from panel

Host Control: Beep Std/

Inverted

Off=beep standard (active low signal from access control panel)

On=beep inverted (active high signal from access control panel)

Output Reporting: Door

Status

Off=normally open door status output (when door closed)

On=normally closed door status output (when door closed)

Output Reporting:

Request to Exit (RTX)

Off=normally open RTX output when lever not depressed

On=normally closed RTX output when lever not depressed

Output Reporting: Spare Off=normally open spare output (normal = key not used/latch extended, locked

position)

On=normally closed spare output (normal = key not used/latch extended, locked

position)

Output Reporting: Spare

Status

Off=spare output provides status of key use (rta) - if lock is equipped w/option

On=spare output provides status of latch bolt monitor (lbm) - if lock is equipped w/

option

Output Reporting: Spare

Provides

Off=spare output does not provide troubles status. Selection on 9 is used

On=spare output provides troubles status. Selection on 9 is ignored

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 86 87

Comentarios a estos manuales

Sin comentarios

Asus E500-PIB Guía de usuario Pagina 45

Comentarios a estos manuales