
34 • Schlage • Schlage Utility Soware User's Guide
Controller PropertiesAD-Series Locks and Controllers
WPR400
EDIT Tab
Property Description Default
Relatch Aer: Timer
Length
Amount of time before the lock re-locks aer being unlocked by a user presenting a
valid credential.
3 seconds
First, Delay, Retry First: First query a Lock makes to a PIM400 occurs immediately following
presentation of a credential. First is the amount of time, in milliseconds, the
WPR400 should wait before making its second query to a PIM400. This setting
should be slightly greater than the fastest response time from the access control
panel or host. This optimizes battery life and system performance.
Delay: The idle time between subsequent queries. Shorter delays may reduce
latency. Longer delays may enhance battery life.
Retry: The maximum number of times the WPR400 queries a PIM400 before
the Lock goes back to sleep. The number of retries should be slightly greater than
the longest response time from the access control panel or host. Retrys = [{Max
Response Time of Panel- First}/ Delay] +1
First: 300
msec.
Delay: 200
msec.
Retry: 5
Degraded (Cache)
Mode: Card Format
Card Bit Format: The number of bits in the credential card number.
0 = Degraded (Cache) mode disabled
0
Degraded (Cache)
Mode: Purge unused
aer 5 days.
If checked deletes the cache entry aer 5 days of non-use.
Degraded (Cache)Mode:
Full Card Number or
Facility Code
Use the full card number or the facility codes of previously approved credentials in
Degraded (Cache) mode.
Full card
number
Card + PIN LED mode Disabled
Mode 1: 2 alternating blinks
Mode 2: Solid Green / 2 red right blinks
1
Wakeup Status Displays the time, in seconds, the lock listens for Wake on Radio broadcasts from its
linked PIM400.
Max Entries Stored Number of credential cards maintained in the cache. Minimum of 5, Maximum of
1275
125
ACP Timeout Time (in seconds) to wait before determining communication from the ACP has
failed.
10 seconds
Comentarios a estos manuales