Asus Motherboard P5LD2 Manual de usuario descargar pdf (Pagina 3)

DocSTAR National Service Page 3 of 15

For further assistance, please contact DocSTAR Technical Support at 1-800-367-5906.

4. Select “RAID1 (Mirror)” for the RAID Level, then press “Enter” twice so that “Create

Volume” is highlighted.

5. Press “Enter” when the “Create Volume” item is highlighted. The following message will

appear.

6. Press “Y” to create the RAID volume and return to the main menu.

7. Press “4” to exit the utility.

Asus NCLV-D2/SATA motherboard LSI RAID controller

The following steps outline how to create/define a RAID1 array using the onboard LSI RAID

controller that’s integrated into the Asus NCLV-D2/SATA motherboard. The Asus NCLV-

D2/SATA motherboard will typically be found in docSTAR SPX and Enterprise systems.

Part A: Configure motherboard BIOS

The following configuration changes need to be made in the motherboard BIOS prior to entering

LSI Logic Embedded SATA RAID Setup Utility:

1. Press the “Delete” key during POST to enter the BIOS setup.

2. Go to the Main Menu, select IDE Configuration, then press “Enter”.

3. Set the Onboard IDE Operate Mode to “Enhanced Mode”.

4. Set the Enhanced Mode Support On item to “S-ATA”, then set the Configure S-ATA as RAID

item to “Yes”.

5. Save your changes and exit the BIOS setup. Then proceed to Part B.

Part B: Create array on the LSI Logic Embedded SATA RAID controller

The following configuration changes need to be made in the LSI Logic Embedded SATA RAID

Setup Utility:

1 2 3 4 5 6 7 8 ... 14 15

Sin comentarios

Asus Motherboard P5LD2 Manual de usuario Pagina 3