Asus Motherboard P5LD2 Manual de usuario descargar pdf (Pagina 14)

DocSTAR National Service Page 14 of 15

For further assistance, please contact DocSTAR Technical Support at 1-800-367-5906.

3. Select “LD 1” and press “Enter”.

4. Select “RAID5” for the RAID mode. Change “Fast Init” to “ON”, this will allow the

controller card to initialize quicker.

5. Arrow down to the “Drive Assignments” section. This section will display all of the hard

drives that are connected to the controller card. In this section, you must change the Assignment

column from “N” to “Y” using the space bar to make a hard drive a member of the array.

Note: The screenshot below shows 4 drives connected to the controller card. The most common

DocSTAR configuration will contain 6 drives. In a 6 drive configuration, it is suggested that 5 of

the 6 drives be members of the array and the remaining drive be a hot spare. To configure the

array with a hot spare, change the assignment to “Y” on drives 1 thru 5, and then leave the

assignment for drive 6 set to “N”. This configuration will give you a RAID5 array with 5 drives

actively in the array and 1 hot spare.

1 2 ... 9 10 11 12 13 14 15

Sin comentarios

Asus Motherboard P5LD2 Manual de usuario Pagina 14