TS700-E7/RS8
2-17
Chapter 2
2.6.3 Installing a hot-swap SATA/SAS hard disk drive
1. Release a drive tray by pushing the
spring lock to the right, and then
pulling the tray lever outward. The
drive tray ejects slightly after you
pull out the lever.
3. Completely pull out the HDD module
cage.
2. Firmly hold the tray lever and pull
the drive tray out of the bay.
3. Take note of the drive tray holes.
different types of hard disk drives.
Use two screws on each side to
secure the hard disk drive.
Comentarios a estos manuales