
Chapter 2: Hardware setup
2-2
2.1 Chassis cover
2.1.1 Remove the front cover
2. Remove the six screws (refer to
the figure for the locations) on
the left and right sides of the
front side of the top cover panel.
3. Loosen the two screws that
scure the top cover panel to the
rear panel (refer to the gure for
the locations). Please note that
do not remove the screws when
loosenning them.
4. Pu s h t h e bac k c o ver p a n el
backward until it is half inch
away from the front side of the
top cover panel.
1. Push the blue button to the right
side and pull the lever outward
(see the figure) to remove the
hard disk tary.
Comentarios a estos manuales