Asus LSI SAS3442X-R Manual de usuario descargar pdf (Pagina 52)

A-4 Using the CFGGEN IR Conﬁguration Utility

CFGGEN is not case sensitive. You can type CFGGEN commands and

parameters in uppercase, lowercase, or a mixture of the two.

The following conventions are used in the command descriptions:

• Text in italics must be entered exactly as shown on the command line.

• Text surrounded by <> must be replaced with a required parameter.

• Text surrounded by [ ] may be replaced by an optional parameter.

• Parameters surrounded by {} must be entered one or more times, as

is appropriate for the command being executed.

• The command line deﬁnition characters <>, [ ], and {} must not be

entered on the command line.

A.3.1 Common Command Line Parameters

This section describes CFGGEN command line parameters that are

common to more than one command.

• <controller #>

The unique controller number of a PCI function found in the system,

starting with controller # 0. For example, in a system containing two

SAS1068 controllers, controller # 0 references the ﬁrst controller and

controller # 1 references the other controller.

Valid controller number values are 0 to 255 (decimal).

• <SCSI ID>

The SCSI bus address of a peripheral device attached to an LSI SAS

controller. The valid SCSI ID values for supported LSI SAS

controllers are 0 to 127 (decimal) per controller.

Note: With PBSRAM, the SAS1068/1068E controllers can

support more than 128 devices.

• <Enclosure:Bay>

The Enclosure and bay/slot of a peripheral device attached to the

bus. The argument must use a colon (:) as a separator and must

follow the enclosure:bay format. This argument is only valid when

used with the bay command line argument. Valid numbers are 0 to

127 (decimal).

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 67 68

Sin comentarios

Asus LSI SAS3442X-R Manual de usuario Pagina 52