4-5ASUS Pundit P1-AH2
4.4 Connectors
1. Serial ATA connectors
(7-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA
hard disk drives.
Important notes on Serial ATA
• Only Windows
®
2000 Service Pack 4 / Windows
®
XP Service Pack1
and above support Serial ATA hard disk drives.
• When using the connectors in Standard IDE mode, connect the primary
(boot) hard disk drive to the SATA1 or SATA2 connector.
2. COM port connector (10-1pin COM1)
This connector is for a serial (COM) port. Connect the serial port
module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
Comentarios a estos manuales