Asus Barebone System T2-PH2 Manual de usuario descargar pdf (Pagina 43)

2-23

ASUS T2-PH2

To install a Serial ATA hard disk drive:

1. Follow steps 1-7 of the previous section.

2. Connect one end of the supplied

7-pin SATA cable (right angle

side) to the SATA connector

at the back of the drive,

then connect the other end

to a SATA connector on the

motherboard. See page 4-9 for

the location of the Serial ATA

connectors.

15-pin SATA

power plug

4-pin (male)

power plug

If your Serial ATA HDD has both 4-pin and 15-pin connectors at the

back, use either the 15-pin SATA power adapter plug OR the legacy

4-pin power connector. DO NOT use both to prevent damage to

components and to keep the system from becoming unstable.

3. For Serial ATA HDDs with a 4-pin

power connector:

a. Connect a 4-pin (female) power plug from the power supply unit

to the 4-pin (male) power connector at the back of the drive. See

page 2-25 for details on the power supply unit plugs.

For Serial ATA HDDs without a 4-pin power connector:

b. Connect the 15-pin SATA power adapter plug to the power

connector at the back of the drive, then connect the other end

(4-pin male) to a 4-pin (female) power plug from the power supply

unit. See page 2-25 for details on the power supply unit plugs.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 113 114

Sin comentarios

Asus Barebone System T2-PH2 Manual de usuario Pagina 43