Asus RS926-E7/RS8 Manual de usuario Pagina 69
- Pagina / 200
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
ASUS RS920-E7/RS8; RS926-E7/RS8 4-15
11. EATX power connectors (24-pin ATXPWR1, 8-pin ATX12V1)
These connectors are for an EATX power supply plugs. The power supply
plugs are designed to t these connectors in only one orientation. Find the
proper orientation and push down rmly until the connectors completely t.
• DO NOT forget to connect the 24+8-pin power plugs; otherwise, the system
will not boot up.
• Use of a PSU with a higher power output is recommended when conguring
a system with more power-consuming devices. The system may become
unstable or may not boot up if the power is inadequate.
• This motherboard supports EATX2.0 PSU or later version.
• Ensure that your power supply unit (PSU) can provide at least the minimum
power required by your system.
- 2U Rackmount 1
- User Guide 1
- First Edition 2
- March 2012 2
- Contents 3
- REACH Information 8
- Safety information 9
- About this guide 10
- References 11
- Conventions 11
- Typography 11
- Product introduction 13
- 1.1 System package contents 14
- 1.2 Serial number label 15
- 1.3 Systemspecications 16
- 1.4 Front panel features 18
- 1.5 Rear panel features 18
- 1.6 Internal features 19
- 1.7 LED information 20
- 1.7.2 LAN (RJ-45) LEDs 21
- LAN5 LEDs 21
- LAN1 to LAN4 LEDs 21
- 1.7.3 HDD status LED 22
- Hardware setup 23
- 2.1 Chassis cover 24
- 2.2.1 Installing the CPU 25
- Chapter 2: Hardware setup2-4 26
- Triangle 27
- Chapter 2: Hardware setup2-6 28
- CPU Installation Sequence: 30
- 2.3 System memory 31
- 2.3.2 MemoryCongurations 32
- Locked Retaining Clip 33
- Unlocked retaining clip 33
- DIMM notch 33
- DIMM slot key 33
- 2.4 Hard disk drives 35
- PCI Express x16 slot 37
- GPU computing module bracket 38
- 2.6 Cable connections 40
- 2.8.1 System fans 42
- Heatsink bracket 45
- DO NOT remove the inner 46
- Installation options 49
- Fixing latch 50
- Latch screws 50
- Rail screws 50
- Rail Washers 50
- Motherboard info 55
- 4.1 Motherboard layout 56
- 4.2 Jumpers 58
- Management Controller 61
- 4.3 Internal connectors 62
- 4.4 Internal LEDs 72
- Q-Code table 75
- BIOS setup 77
- Drive Folder Info 79
- 5.1.3 BUPDATER utility 80
- Writing BIOS: 81
- 5.2 BIOS setup program 82
- 5.2.2 Menu bar 83
- 5.2.1 BIOS menu screen 83
- 5-8 Chapter 5: BIOS setup 84
- 5.3 Main menu 85
- 5.4 Advanced menu 86
- 5-12 Chapter 5: BIOS setup 88
- 5-14 Chapter 5: BIOS setup 90
- 5.4.3 ChipsetConguration 91
- 5-16 Chapter 5: BIOS setup 92
- Intel(R) I/OAT [Disabled] 94
- DCA Support [Enabled] 94
- VGA Priority [offboard] 94
- CPUIIOBridgeConguration 94
- DIMM Information 94
- 5.4.4 PCHSATAConguration 96
- SATA Mode [AHCI Mode] 97
- Staggered Spin-up [Disabled] 97
- 5.4.6 PCI Subsystem Settings 98
- 5.4.5 PCHSCUConguration 98
- 5-24 Chapter 5: BIOS setup 100
- Intel LAN Support 101
- Intel LAN4 Enable [Enabled] 102
- 5.4.8 USBConguration 103
- 5.4.9 Trusted Computing 104
- 5.4.10 ACPI Settings 105
- 5.4.11 WHEAConguration 106
- 5.4.12 APM setting 106
- Console Redirection Settings 107
- Console Redirection [Enabled] 108
- 5.4.14 ME Subsystem 110
- Advanced 111
- 5.5 Server Mgmt menu 112
- 5.5.1 System Event Log 113
- Station IP address [0.0.0.0] 114
- Subnet mask [0.0.0.0] 114
- Gateway IP address [0.0.0.0] 114
- 5.6 Event Logs menu 115
- View Smbios Event Log 116
- View System Event Log 116
- 5.7 Boot menu 117
- UEFI Boot [Disabled] 118
- Boot Option Priorities 118
- 5.8 Monitor menu 119
- 5.9 Security menu 120
- User Password 121
- Administrator Password 121
- 5.10 Tool menu 122
- 5.11 Exit menu 122
- 5-48 Chapter 5: BIOS setup 124
- RAIDconguration 125
- 6.1 Setting up RAID 126
- 6.2.1 Creating a RAID set 129
- Choose RAID Level For This VD 131
- Select Units For VD Size 132
- Select Yes Or No 133
- UsingNewConguration 134
- Using the Initialize command 136
- UsingtheObjectscommand 138
- BIOS Version A.10.09231523R 139
- Rebuild PD(s) 140
- Check Consistency 142
- Select VD 143
- 6.2.8 Enabling WriteCache 147
- 6.3 Intel 148
- Rapid Storage Technology 148
- 6.3.1 Creating a RAID set 150
- 6.3.3 Deleting a RAID set 153
- 6.3.6 Rebuilding the RAID 155
- 6.3.5 Exiting the Intel 155
- 6.4 Intel 158
- 6.4.1 Creating a RAID set 159
- 6.4.2 Change Volume Type 161
- 6.4.3 Delete volume 162
- 6.4.4 Preferences 163
- Driver installation 165
- 7.1 RAID driver installation 166
- LSI 2008 SAS2 Driver 167
- During Windows 168
- Server 2008 OS installation 168
- Enterprise Linux OS 5.6 170
- More Driver Disks? 171
- Do you wish to load any more 171
- Enterprise Linux OS 6.1 172
- Preparing the Linux Driver 175
- Installing SUSE 11 Linux OS 176
- <Enter> 177
- 7.2 Intel 179
- chipset device software 179
- 7.3 Intel 181
- 9. When nished, press 183
- to continue 183
- 7.4 VGA driver installation 184
- 8. Click 186
- 7.5 Intel 187
- 7.7 Intel 189
- 7.8 Intel 192
- 9. Click 195
- to nish the installation 195
- 7.9.2 Drivers menu 196
- 7.9.3 Utilities menu 197
- 7.9.4 Make disk menu 197
- 7.9.5 Contact information 197
- ASUS contact information 199
Relacionado con productos y manuales para Hardware De La Computadora Asus RS926-E7/RS8
(112 paginas)
Hardware De La Computadora Asus P7F-M Manual de usuario
(160 paginas)
(160 paginas)
Hardware De La Computadora Asus TC715 Manual de usuario
(106 paginas)
(106 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.059 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales