Asus RS260-E4/RX8 Manual de usuario Pagina 117
- Pagina / 182
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
ASUS RS260-E4/RX8 5-31
The following items appear only if you enable the
Power On By RTC Alarm
item.
RTC Alarm Date [0]
To set the date of alarm, highlight this item and press <Enter> to display a date
chart. Press <+> or <-> to change scroll through the options, then press <Enter>
when done. The default setting [0] is equivalent to everyday alarm.
Conguration options: [0] [1] ~ [31]
RTC Alarm Date [00 : 00 : 00]
To set the time of alarm:
1. Press <+> or <-> to set the desired value.
2. Press <Tab> to move to the next eld.
3. Press <Enter> when done.
ItemSpecicHelp
To select the fan speed
control model.
Hardware Monitor
CPU1 Domain 0 Temperature 39
o
C/102
o
F
CPU1 Domain 1 Temperature 29
o
C/84
o
F
CPU2 Domain 0 Temperature 0
o
C/32
o
F
CPU2 Domain 1 Temperature 0
o
C/32
o
F
SYSTEM1 Temperature 39
o
C/102
o
F
SYSTEM2 Temperature 29
o
C/84
o
F
CPU_FAN1 Speed 2925 RPM
CPU_FAN2 Speed N/A
FRN_FAN1 Speed N/A
FRN_FAN2 Speed N/A
FRN_FAN3 Speed N/A
FRN_FAN4 Speed N/A
REAR_FAN1 Speed N/A
REAR_FAN2 Speed N/A
Smart Fan Control [Smart Fan II]
PhoenixBIOS Setup Utility
Advanced
5.4.8 Hardware Monitor
This menu shows the hardware monitor conguration settings. Select an item then
press <Enter> to display the conguration options.
The following screens appear when you install Intel
®
5000 series CPU.
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →← : Select Menu Enter: Select SubMenu F10: Save and Exit
- RS260-E4/RX8 1
- First edition V1 2
- November 2006 2
- Contents 3
- Appendix: References 6
- Safety information 8
- About this guide 9
- Conventions 10
- Reference 10
- Product introduction 11
- 1.1 System package contents 12
- 1.2 Systemspecications 13
- 1.3 Front panel features 15
- 1.4 Rear panel features 15
- 1.5 Internal features 16
- 1.6 LED information 17
- 1.6.2 System fan LED 18
- 1.6.3 Power supply LED 19
- 1.6.4 LAN port LEDs 19
- Hardware setup 21
- 2.1 Chassis cover 22
- 2.1.2 Removing the top cover 23
- Rear half 24
- ASUS RS260-E4/RX8 2-5 25
- 2.1.4 Removing the air duct 26
- ASUS RS260-E4/RX8 2-7 27
- 2.2.1 Installing a CPU 28
- Alignment key 29
- Gold triangle mark 29
- Load plate 29
- 2.3 System memory 31
- Rank population 32
- Memory Mirroring 33
- (Mirror) 34
- Memory Sparing 35
- Two DIMMs per channel 36
- Three DIMMs per channel 36
- 2.3.3 Installing a DIMM 37
- 2.3.4 Removing a DIMM 37
- 2.4 Hard disk drives 38
- ASUS RS260-E4/RX8 2-19 39
- 2.5 Expansion cards 40
- ASUS RS260-E4/RX8 2-21 41
- PCI cage pegs 42
- DSBF-D12/2U/SAS 43
- 2.5.5 Interrupt assignments 45
- 2.5.3 DDR2 SO-DIMM socket 45
- 2.6 Cable connections 46
- 2.6.1 Motherboard 47
- 2.6.2 SAS backplane 48
- 2.6.3 Fan boards 49
- 2.7 Removable components 50
- 2.7.2 Power supply modules 51
- ASUS RS260-E4/RX8 2-33 53
- 2.7.5 SAS backplane 55
- 2.7.6 System fan board 55
- 2.7.7 Power supply cage 57
- 2.7.8 LAN adapter (Optional) 58
- 2.7.9 LAN cable 58
- Installation options 59
- 3.1 Rackmount rail kit items 60
- ASUS RS260-E4/RX8 3-3 61
- 3.3 Attaching the rack rails 62
- ASUS RS260-E4/RX8 3-5 63
- 3.4 Rackmounting the server 64
- Motherboard info 65
- 4.1 Motherboard layout 66
- 4.1.2 Layout contents 67
- Heatsink hole 68
- Socket for CPU1 68
- Socket for CPU2 68
- ASUS RS260-E4/RX8 4-5 69
- 4.3 Jumpers 70
- DSBF-D12/2U/SAS VGA setting 72
- OFF(Default) 74
- 1 2 3 4 5 6 7 8 74
- 4.5 Connectors 75
- ADD_IN_CARD 76
- ASUS RS260-E4/RX8 4-13 77
- +3.3V Remote Sense 79
- I2C_7_DATA# 79
- I2C_7_CLK# 79
- 24-pin Power Connector 80
- +12V DC GND 80
- SATA_SCLK 82
- SATA_SLOAD 82
- SDATAOUT1 82
- SDATAOUT0 82
- ASUS RS260-E4/RX8 4-19 83
- AUX_PANEL1 84
- BIOS setup 87
- DOS environment 88
- XP environment 88
- Utility 89
- 5-4 Chapter 5: BIOS setup 90
- ASUS RS260-E4/RX8 5-5 91
- 5.2 BIOS setup program 92
- 4.2.2 Menu bar 93
- 5.2.1 BIOS menu screen 93
- 5.2.4 Menu items 94
- 5.2.5 Sub-menu items 94
- 5.2.6 Congurationelds 94
- 5.2.3 Legend bar 94
- 5.2.7 Pop-up window 95
- 5.2.8 General help 95
- 5.3 Main menu 96
- S-ATAConguration 97
- Native Mode Operation [Auto] 98
- Serial ATA [Enabled] 98
- Type [Auto] 99
- 5.3.6 SATA Port 1/2/3/4 100
- LBA Mode Control [Disabled] 101
- 32-Bit I/O [Disabled] 101
- Transfer Mode [Stadard] 101
- Ultra DMA Mode [Disabled] 101
- 5.3.7 System Information 102
- Processor Information 103
- System Memory Information 103
- 5.4 Advanced menu 104
- ASUS RS260-E4/RX8 5-19 105
- Echo TPR [Disabled] 106
- Intel EIST support [Disabled] 106
- 5.4.2 ChipsetConguration 107
- 5-22 Chapter 5: BIOS setup 108
- ASUS RS260-E4/RX8 5-23 109
- 5.4.3 PCIConguration 110
- PCI Device, Slot #1 ~ 6 111
- USB Function [Enabled] 112
- USB 2.0 Controller [Enabled] 112
- Legacy USB Support [Enabled] 112
- COM1 Port [Enabled] 113
- COM2 Port [Enabled] 113
- Parallel port [Enabled] 114
- 5.4.6 ACPIConguration 115
- 5.4.7 PowerOnConguration 116
- 5.4.8 Hardware Monitor 117
- 5-32 Chapter 5: BIOS setup 118
- CPU1/2 Target Temperature 119
- 5.5 Server menu 120
- ASUS RS260-E4/RX8 5-35 121
- Com Port Address 121
- item to 121
- 5.5.2 DMI Event Logging 122
- 5.6 Security menu 123
- Password Check [Setup] 124
- Password Lock Mode [Enabled] 124
- Flash Write [Enabled] 124
- 5.7 Boot menu 125
- 5.7.2 Boot Features 126
- 5.8 Exit menu 127
- Discard Changes 128
- Load Setup Defaults 128
- RAIDconguration 129
- 6.1 Setting up RAID 130
- ASUS RS260-E4/RX8 6-3 131
- LSI Logic Corp. MPT SAS BIOS 132
- Adapter(s) disabled by user 132
- ASUS RS260-E4/RX8 6-5 133
- Create and save new array? 137
- Cancel Exit 137
- Overview 138
- 6.2.4 Managing Arrays 141
- Managing hot spares 143
- Synchronizing the array 144
- Activating an array 145
- Deleting an array 145
- 6.2.5 Viewing SAS topology 146
- Selecting a boot disk 147
- 6.2.6 Global Properties 148
- Boot Information Display Mode 149
- Support Interrupt 149
- Restore Defaults 150
- Driver installation 151
- 7.1 RAID driver installation 152
- 2000/2003 Server OS 153
- To an existing Windows 155
- Enterprise 157
- ASUS RS260-E4/RX8 7-9 159
- SuSE Linux 160
- ASUS RS260-E4/RX8 7-11 161
- ASUS RS260-E4/RX8 7-13 163
- 7.3 LAN driver installation 165
- ASUS RS260-E4/RX8 7-17 167
- 9. When nished, press 168
- to continue 168
- ASUS RS260-E4/RX8 7-19 169
- 7.3.2 Red Hat/SuSE Linux 170
- 7.4 VGA driver installation 171
- 5. Select 172
- ASUS RS260-E4/RX8 7-23 173
- installation 174
- 7.5.4 Utilities menu 175
- 7.5.5 Contact information 175
- References 177
- A.1 Power supply 178
- A.1.2 Specications 179
- A.2 Troubleshooting 180
- Problem Action 181
- Appendix: ReferencesA-6 182
Relacionado con productos y manuales para Hardware De La Computadora Asus RS260-E4/RX8
Hardware De La Computadora Asus P9D-V Manual de usuario
(150 paginas)
(150 paginas)
Hardware De La Computadora Asus NCT-D Manual de usuario
(112 paginas)
(112 paginas)
Hardware De La Computadora Asus DSBV-D Manual de usuario
(168 paginas)
(168 paginas)
Hardware De La Computadora Asus P9D WS Manual de usuario
(154 paginas)
(154 paginas)
Hardware De La Computadora Asus P5MT Manual de usuario
(176 paginas)
(176 paginas)
Hardware De La Computadora Asus P8B-MX Manual de usuario
(150 paginas)
(150 paginas)
Hardware De La Computadora Asus AW171 Manual de usuario
(116 paginas)
(116 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.031 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales